NOTE! If you don't see the driver in the list, please proceed to SoundID Reference Driver.Įvery audio device stores a profile in the Audio MIDI Setup utility. Double-check with the Mute box and make sure that you haven't accidentally ticked it. Make sure that SoundID Reference is assigned as your audio output device correctly so you would route the sound to the SoundID Reference. Go to: System Settings -> Sound -> Output Usually, SoundID reference automatically sets it up and selects once you run the software. Once you install and launch SoundID reference the special virtual device is created. Your next step would be referring to your MAC Preferences.
Please follow the link for further guidance in regards to in-app activity.
Thus first of all we advise you to check on your app settings paying extra attention to both input and output being set up correctly. Therefore, a signal going into the SoundID Reference would be called SoundID input, as the signal going to the physical output device would be classed as SoundID output. The audio signal from various sources on your computer is routed to SoundID Reference, where it gets calibrated, and is then sent out to the physical output device selected in SoundID Reference. You may play a test tone from the SoundID Reference app Output settings to define whether the signal gets through to the selected output device.īefore we get any further, we will give you a basic idea of how the app works: SoundID Reference acts as a middleman between the audio sources on your computer and the hardware output device.Check if calibration in the SoundID Reference app is enabled.SoundID Reference master fader and the Dry/Wet knob.Audio source app (media player, browser, DAW, etc.).Final physical output (monitor controller, speakers, headphones).Audio interface (virtual mixer software I/O channels and/or physical outputs).Cables, connections, adapters, ON/OFF switches, etc.Please make sure you have double-checked on the following before you start troubleshooting the rest. Please look through the following guide if you either don't hear any audio at all or can't notice the calibration effect.īefore you start digging deeper, please check on a few simple things. We have gathered a list of quick and simple resolutions for the most common issues. In the majority of cases, SoundID Reference malfunctioning in regards to the lack of sound or calibration effect is a result of either a poor setup or software incompatibility.
0 kommentar(er)
